Spa jet/eyeball stuck
- By ajw22
- Everything Else
- 1 Replies
If you close a jet it will increase the flow and pressure in the other open jets.
I thought it was 18" but to be honest now I'm not too sure. I'll have to measure it and find out.Thanks for sharing! How wide is your bench - 16”?
He said he wanted to give us the heater right before our current heater. I can ask for the specific number.
He said the test he used doesn't test for salt? Does that make sense?
Did your builder open up the heater internals and examine the heat exchanger?Please see attached pics. Let me know if you need more.
Not unless Pentair helps you load it.So, is it possible to install 1.047 just for testing?
If you want any additional pictures that you don't see in my existing media just let me knowThanks! That is super helpful to know.
I was afraid of that (not knowing how to manage equipment/water chemistry).Show us pictures of the heater.
The JXI400N is a workhorse that is fine for many people. Your Pool Builder may build fine pools but does not know how to properly manage pool equipment and water chemistry.
What model old heater does he want to give you?
Get your own test kit. Taylor K-2006C or Test Kits .
Test Kits Compared
The water chemistry from your builder is sketchy.
You should have adopted TFP methods last year when you were here.
Hi Jim,Jerry,
You have two pumps.. One is your main pool/spa pump, depending on how the Intake and Return valve are positioned.
I 'assume' the other pump is just for your spa jets... Is this true? If so, when you turn on the Spa circuit, do both pumps come on, or just the main pump?
If you can, show me the "Circuits" page from your app.
I also 'assume' that when you are in the pool mode, that your spa spills over into your pool.. Is that true?? Does this happen all the time, or just a couple of times a day.
I do not see a way to turn your 2nd pump on or off from your EasyTouch panel??? Is it controlled by one of the unlabeled buttons?
To be honest, I'm trying to figure out how your spa gets water to spillover...At the moment it does not make sense to me..
Thanks,
Jim R.
Probably remove the tape as the extra stress can crack those unions.Thank you @JamesW and everyone who chimed in. Replaced the oring (#228) and applied teflon tape, fixed the leak for good! Got some backup O-rings as well.