Latest activity Postings Media About
-
-
ajw22 replied to the thread IntelliCenter question.That accounts for two of the 240V breakers. What does the other one power? -
ajw22 replied to the thread Help Me Understand My Pool Setup.They are both screwed into threaded sockets in the PVC and will unscrew if you get the pipe free.
-
ajw22 replied to the thread Advice for Replacement Pump.All of the VS pumps control VS motors this way. Why do you care? They need 240V or 120V line power in to work.
-
ajw22 replied to the thread Hairline crack leak on pipe to chlorinator.Thanks for spotting that. Good to know about the difference in ID between CPVC and PVC.
-
ajw22 replied to the thread Spa OFF at Midnight.I set the Egg Timer on the SPA circuit for 3 hours so the spa will always turn off 3 hours after I turn it on. You can't set a specific...
-
ajw22 replied to the thread Should I be using my spa (spill-over) in DFW during the winter?.Yes, there are different designs used for handing the exhaust and condensation in gas heaters. I would still be cautious with operating...
-
ajw22 replied to the thread Hairline crack leak on pipe to chlorinator.I don't think that is a good idea for this situation. You can see a bunch of goop put on the elbow and the pipe where people tried to...
-
ajw22 replied to the thread Pentair Mastertemp 250 24 VAC short keeps blowing fuse.Measure the ohms of each wire in J1 between the wire and GROUND. The only connection at the ICM that should have zero or near zero ohms...
-
-
-
ajw22 replied to the thread Help Me Understand My Pool Setup.From https://www.hayward-pool.com/assets/documents/pools/pdf/manuals/Heat-Pump-Owners-Manual.pdf
-
-
-
ajw22 replied to the thread Help Me Understand My Pool Setup.Check your building codes. You may need 3 feet of clearance in front of any electrical panels on the wall. I can't see exactly what you...
-
ajw22 replied to the thread Adjusting Pool/Spa Lights.Look on your EasyTouch config if your light is controlled by one AUX. Look at the wiring on the EasyTouch Panel and identify the light...
-
ajw22 replied to the thread Jandy 2 Speed Pump Wiring.That should work. You use switch2 to turn power on or off the relay coil and switch LINE2 of the pump between the HIGH and LOW speed...
-
ajw22 replied to the thread Basic Pool Light Advice Wanted....Use a Pentair Amerlite incadescent pool light and replace the bulb with an LED bulb like you had in your last pool...
-
-
Loading…
-
Loading…
-
Loading…
