Latest activity
1
1poolman1 replied to the thread Filter gauge.
The gauge should NEVER be threaded that far into the port. Remove the gauge, turn the pump on. Does water spray out of the port? If so...
Rancho Cost-a-Lotta replied to the thread SWG in my future?.
There are lots of SWG owners with high calcium content. We found that to maintaining lower TA level (60 ppm) and negative CSI helps to...
B
Bperry replied to the thread Testing FC levels.
That normal as said above. But get some chlorine in the water cause if it turns clear after one drop that means there’s basically zero...
P
paul1971 replied to the thread Test after opening salt pool.
Hi again. So Fc is dropping fast, now at 9. CYA looks like is at 35, quite low. Should i add stabilizer and if so what kind? Or just...
J
jobondur posted the thread DE Filter Pressure Gauge Registering Too Low in Pumps, Filters, and Plumbing.
Opened my pool and everything was working fine. Then at some point, my DE filter pressure gauge went to what looked like zero. I...
B
Bperry replied to the thread Water is still cloudy after multiple treatments.
They aren’t very accurate and tend to give really bad advice based on the bad test data. Did they really tell you 16lbs of dry acid?
PoolGate replied to the thread Jandy Aquapure 1400.
There is deeper troubleshooting that can be done. Hopefully your technician is doing that.
Here is the FULL troubleshooting guide...
ajw22 replied to the thread Help with Pentair Mastertemp debug.
How long does the heater run before throwing the AGS error?
Read Pentair MasterTemp Heaters - Further Reading
B
Bperry replied to the thread Green pool not clearing.
Been a warm winter, you should consider opening by end of March in the future. That’ll help avoid the green on opening.
5 days isn’t...
Mdragger88 replied to the thread Water is still cloudy after multiple treatments.
Please let us know what test kit you have and please don’t acid bomb your pool with 10# of dry acid.
Do all the tests yourself & report...
M
Megarms replied to the thread Jandy Aquapure 1400.
Yeah, i have the box. It is a genuine, brand new replacement. I suppose we will need another new cell if the new board doesnt fix it.
1
1poolman1 replied to the thread Motor noise.
You have what looks to be a .5hp full-rate/.75hp uprated Hayward MaxFlo pump.
Hopefully, your impeller is a SPX2605C, a .5hp impeller...
P
I have 30 lbs at my filter but only 2 lbs at Caretaker gauge. If I undo the clamp to take the whole dome off I get all five ports on the...
PoolStored replied to the thread Green pool not clearing.
Increase the frequency of your testing and replacing FC. Not more than every 2 hours, and no less than 3-4x per day.
The more often you...
Donldson replied to the thread Water is still cloudy after multiple treatments.
Quite simply: why would you trust the testing that's being done for free just to get you in the door and sell you products? Did you...
PoolStored replied to the thread Filter gauge.
ugh.
That indicates that they had a problem getting it to seal. That may mean that they overtightened a gauge at some point and...
PoolGate replied to the thread Jandy Aquapure 1400.
That typically would be indicative of cell failure. Perhaps your new cell has also failed or was defective to begin with. This is a...
H
HeidiP replied to the thread Replacing a Section of Rusted Pool Wall Questions.
So what happened in the end? I bolted some last year and I’m dealing with a split and replacement this year.
M
Megarms replied to the thread Jandy Aquapure 1400.
The funny thing is, it will slide into Service Mode and then slide itself out later. Normally happens during cell resting or cell...
PoolGate replied to the thread Jandy Aquapure 1400.
Well howdy neighbor!
It shows the 123 error. It for sure is having issues. With a 123 error, it may not be producing any chlorine...
Maverick2022 replied to the thread Water Test 5-8-2025.
Thank you! I did update my signature, so that should help to answer my equipment questions (3" tablet chlorinator, Sand Dollar SD40 sand...
F
Hello All,
I am at the point of throwing this thing away. From the first few uses, the on switch became difficult to depress and...
Mdragger88 replied to the thread 18 x 33 x 56" Semi-In Ground NJ.
Definitely forget the toilet paper math on the packages -
is the only way to go.
Glad you didn’t get any bleaching from the cya spill...
R
rchesani replied to the thread Green pool not clearing.
PoolMath Logs
U
Uhhello replied to the thread Water is still cloudy after multiple treatments.
A bunch of reasons but if you have the kit, why wouldn't you test it yourself?
M
Megarms replied to the thread Jandy Aquapure 1400.
I know it says 75%, but trust me when I say it does this at 100% as well.
Looks like we are in same climate. I’m in Sykesville
KBreuer15 replied to the thread Water is still cloudy after multiple treatments.
But they test the water for me. Right? I have my own test kits. Both strips and more advance solution based kits. But why is bad to have...