1
Latest activity Postings Media About
-
-
11poolman1 replied to the thread Hayward pump not working.That is a 1.5hp "uprated" motor/pump. Not a problem just a bit confusing. A full-rated motor would be 2.25thp. That's the kind of...
-
11poolman1 replied to the thread Plumbed 1.5" into a 2" system.Not running all the water through the heater may cause the pressure switch to "bounce" and not stay closed, exacerbating the issue. The...
-
11poolman1 replied to the thread What's clogging my chlorine feeder output tubing?.New system may have a drain valve. Liquidator was/is "dump and refill." When I was actively servicing those systems I had a 1/4"...
-
11poolman1 replied to the thread Nautilus NS-60 Valve replacement.New valve should attach to those bulkhead fittings with no issue. May want to get a push/pull valve instead of MPV.
-
11poolman1 replied to the thread Plumbed 1.5" into a 2" system.An issue you have is all the 90's in the system. Is the valve after the filter a heater bypass? The check valve appears to be in use...
-
11poolman1 replied to the thread Cellulose Fiber Clear conversion.Its a soft white powdery material when dry, but expands and forms a "mat" on the top of a sand bed when wet. Most, if not all, will be...
-
11poolman1 replied to the thread Faulty Sand Filter**? Need Advice.Adding more sand is not going to solve the problem if the right amount was added at the beginning. You will take up the "freeboard," the...
-
11poolman1 replied to the thread Cellulose Fiber Clear conversion.If you were servicing commercial pools and went from 100# of DE per week to 25# cellulose per month, backwashing twice a week instead of...
-
11poolman1 replied to the thread Hayward Ecostar VS automation over RS485.EcoStar pumps came with a "blank" control panel. You would replace the control with it and remote mount the working panel. Instructions...
-
11poolman1 replied to the thread Heater left "on" when in Low Flow.No harm to heater. Just won't light if all is well. Not the best way, but won't cause damage.
-
11poolman1 replied to the thread Autofill Never Stops Running.Adjust the float down a bit more.
-
11poolman1 replied to the thread Pump/ filter distance from above ground pool.Two different types of pump. Both too large, single-speed pumps. You really want a VSP. A Hayward Max-Flo VS or Super Pump VS would be good.
-
11poolman1 replied to the thread Mastertemp 400 and diverter valve position.
-
11poolman1 replied to the thread Featured Stain on Skimmer.Big name is GLB Sequa-Sol.
-
11poolman1 replied to the thread Spa jets are a mess.Are those true jets? If so, were the orifices installed? They could be "tee jets." A 1.5" tee would have an insert installed then the...
-
-
Loading…
-
Loading…
-
Loading…