Just had RJ60+ wired by electrician to a T104 timer and when power is on, and everything is connected, It just displays "Cell Connection". Cant seem to find out what the issue is...
Circupool RJ60+ conncetion
- Thread starter SWATC
- Start date
- May 3, 2014
- 58,369
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Can you fill out your signature so we know what equipment you have?
I assume the pump is running at a rate high enough to close the flow switch. Also you have sufficient salt in the water and the water is warm enough for the cell to run.
I will call in @circupool
I assume the pump is running at a rate high enough to close the flow switch. Also you have sufficient salt in the water and the water is warm enough for the cell to run.
I will call in @circupool
Flatag
0
Make sure the pins in the plug on the housing you plug the cell cable into are not pushed into to connector.
I was contacted by Circupool right away after posting and emailing. They were very prompt to send me a whole new set up after trouble shooting a few things. It arrives today so hopefully its up and running tomorrow.
Similar threads
