Just had RJ60+ wired by electrician to a T104 timer and when power is on, and everything is connected, It just displays "Cell Connection". Cant seem to find out what the issue is...
Can you fill out your signature so we know what equipment you have?
I assume the pump is running at a rate high enough to close the flow switch. Also you have sufficient salt in the water and the water is warm enough for the cell to run.
I was contacted by Circupool right away after posting and emailing. They were very prompt to send me a whole new set up after trouble shooting a few things. It arrives today so hopefully its up and running tomorrow.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!