=Pool Automation=
...e sure your water is balanced.<ref>https://www.troublefreepool.com/threads/automation.179649/post-1588112</ref>
5 KB (948 words) - 23:29, 20 November 2024
=Heater Control with Automation=
...ters temperature control is usually set to the maximum temperature and the automation control the heater operation to maintain its water temperature set point.
6 KB (1,006 words) - 11:40, 31 May 2020
Temperature sensors for Pentair, Hayward, Jandy, and other pool automation systems are usually standard 10K ohm NTC thermistor sensors. They are used
...d. This means the resistance goes down as the temperature goes up. All the automation systems use the same sensor and if you look at the resistance verses temper
6 KB (856 words) - 00:33, 10 May 2022
==Automation==
...Aqualink, and Intermatic controls using available high voltage relays. The automation board is compatible with the Calimar, Circupool, and B+D pumps and allows f
6 KB (909 words) - 15:33, 11 September 2023
=Pentair SuperFlo VS Pumps=
...e a voltage selection switch. These VS pumps are a direct replacement for Pentair SuperFlow pumps and the Hayward Super Pump.
11 KB (1,704 words) - 13:53, 28 April 2025
This systems can be used together with automation or independent. There are many models of stenner pumps but the ideal for po
== Pentair IntellipH==
6 KB (887 words) - 12:41, 1 April 2025
=Pentair UltraTemp Heat Pump=
...ts/pool-spa-equipment/pool-heaters/ultratemp_high_performanceheatpump.html Pentair UltraTemp] is a Heat Pump with models having 70,000 to 140,000 BTUs of heat
15 KB (2,315 words) - 19:46, 19 December 2024
=Pentair IntelliFlo Pumps=
...able. When connected to an automation system the pump is controlled by the automation system and the display on the pump display "DISPLAY NOT ACTIVE'. Otherwise
19 KB (2,870 words) - 23:31, 9 April 2025
=Pentair iChlor SWG=
...tion/sanitizers-and-water-quality-2025-2026/sec11_sanitizers_2025-2026.pdf Pentair Sanitizer & Water Quality Catalog 2025-2026]
9 KB (1,405 words) - 23:53, 21 December 2024
...on to another. The valve actuators are powered by 24V AC and plug into an automation panel.
...to manually rotate the valve and to synchronize the set positions with the automation panel.
18 KB (2,798 words) - 23:55, 21 April 2025
The Pentair Comsys described below positions the cells vertically, likely for gas bubbl
A pool automation system can only control one SWG.
7 KB (995 words) - 22:04, 7 March 2025
...er in the pool]], pool use, pool features, and the amount of technology or automation chosen.
...artridge filter, a big variable-speed pump, a SWCG 2X the pool volume, and automation are good choices for a new pool.
20 KB (3,297 words) - 14:41, 1 January 2025
...major pool equipment manufacturers all sell heat pumps—Pentair with the [[Pentair UltraTemp Heat Pump|UltraTemp]], Jandy with the VersaTemp JRT Series, and H
...ffer between manufacturers is the warranty and service, controls, and pool automation communication.
14 KB (2,247 words) - 01:01, 21 March 2025
...rilite in 400-watt and 500-watt, 120-volt models. The Pentair [https://www.pentair.com/en-us/products/residential/pool-spa-equipment/pool-lighting/amerlite.ht
*Light Controls and Automation Compatibility
26 KB (4,025 words) - 00:40, 4 May 2025
...Optimized-Solutions-for-Even-More-Pools-and-Spas.html</ref> as a mid-range automation solution for pools that did not need all the capabilities of the Hayward Om
...R.<ref>https://www.troublefreepool.com/threads/omni-pl-upgrade-kit-hayward-automation.245707/post-2476588</ref>
13 KB (1,908 words) - 22:03, 29 April 2025
In December 2024, Pentair announced [https://www.pentair.com/intellichlor-plus-lt IntelliChlor Plus & LT Salt Chlorine Generators] t
*Drop-in replacement for existing Pentair salt chlorine generators requires no additional plumbing.
27 KB (4,205 words) - 15:26, 27 March 2025
Pentair has the T40B autofill with a side-mounted float valve in almond, black, gra
Pentair Brass Valve Float - T26 will replace the float and brass valve.
10 KB (1,638 words) - 23:08, 20 November 2024
*Pentair tries to keep the current constant by changing the voltage
So, let's take a Pentair IC60 system that is going for $1600 today. It produces 9.2 FC daily in 26k
21 KB (3,458 words) - 23:42, 5 May 2025
...panels are very basic. Others have advanced controls. If you don't have an automation controller for your VS pump, review the pump's Owner's Manual. You should u
...ompatible. Check manufacturer websites and our Wiki pages for the specific automation and pumps you are considering.
28 KB (4,756 words) - 13:58, 29 April 2025
...d [[Valve Actuators]] can be screwed on top of a diverter valve for a pool automation system to change the valve position.
====Pentair====
12 KB (2,019 words) - 22:34, 24 December 2024
