Hello! I am new to the forum. Well after about 3.5 years of use, our Intex Ultra is on life support. We had it set up by a local pool installer as we were new to pools. We had an 8x12 deck built at the narrow end. The pool was first set up SWG but that was putting too much copper in the pool. We reverted to chlorine about this time last year. We recently discovered the corner joint/top rail has a hole rusted through it. We can fit about 4 fingers in it. We also have a small hole that is not patched. Just hope it hold up a couple months until our new pool arrives.
The new. We ordered a 15x30 52" (about 11,500 gallons) Discovery XL hybrid pool. The local place sets it up with a 19'' sand filter and hayward 1.5 hp pump. We opted for a secondary floor drain to be added as well. We are currently thinking about how we are going to sanitize this pool. We were looking at the Frog system. Our neighbor has it and likes it but the pool company says skip it. We are also thinking about a hayward chlorinator or liquid chlorine. We will have to get a slight modification to our deck sometime. What else should we look into being this will be our first permeant pool.
The new. We ordered a 15x30 52" (about 11,500 gallons) Discovery XL hybrid pool. The local place sets it up with a 19'' sand filter and hayward 1.5 hp pump. We opted for a secondary floor drain to be added as well. We are currently thinking about how we are going to sanitize this pool. We were looking at the Frog system. Our neighbor has it and likes it but the pool company says skip it. We are also thinking about a hayward chlorinator or liquid chlorine. We will have to get a slight modification to our deck sometime. What else should we look into being this will be our first permeant pool.