C
Report

cj133

Well-known member From NJ
Messages
570
Media
28
Featured content
0
Reaction score
138
Points
0
Joined
Last seen
Follow
Start conversation

Latest activity Postings Media About

    • C
      cj133 replied to the thread Intex pool paver question.
      Really, the legs should be as close to the center of the pavers as possible. Even if they're fully on, but right at the end that's not...
    • C
      cj133 replied to the thread Leaking threaded joints.
      The quality of these threads is uncalled for. They're disgraceful. The pipe threads, not the ones on the forum.
    • C
      cj133 replied to the thread Sand filter spitting dirt out.
      I have no idea? I wouldn't run two in series. But I'm not sure what you were thinking.
    • C
      cj133 replied to the thread Sand filter spitting dirt out.
      I've seen filters sometimes trap dirt in areas that seems to break loose when switching things I.E. backwash to rinse, to filter etc. If...
    • C
      cj133 replied to the thread AGP Out of Round.
      Looks like dirt, but don't forget without stabilizer chlorine disappears very rapidly from sunlight. So if you have a lot in the...
    • C
      cj133 replied to the thread AGP Out of Round.
      Which pump do you have? I have a Hayward matrix 1.5hp 2 speed that in reality is a 1hp pump. They lie through the service factor rating...
    • C
      cj133 reacted to MVK's post in the thread AGP Out of Round with Like Like.
      I think I got it, just needed to tighten a little more, I’m all good now! Thanks for all the help and advice… hose finally off, good to go!
    • C
      cj133 replied to the thread AGP Out of Round.
      I used the gasket the way Hayward said and have no leaks after 3 years. The gasket seals against the back of the liner and it works fine.
    • C
      cj133 replied to the thread AGP Out of Round.
      When I filled my pools I kept them running all night and set an alarm to get me up when it would be close to full
    • C
      cj133 replied to the thread AGP Out of Round.
      Make sure all of the uprights can move freely on the patio blocks because they're going to move when you fill it. Some may move a lot...
    • C
      cj133 replied to the thread Condensation or leak?.
      Do you see any evidence that the pool is sweating? If not it's not condensation
    • C
      cj133 replied to the thread High output return eyeball / diverter?.
      In my case I had two reasons. 1, to increase pressure at low speed and help circulation. 2, to stop cavitation in high speed. While...
    • C
      cj133 replied to the thread High output return eyeball / diverter?.
      Are you sure you're not running that VS pump way too fast? I had considered reducing my eyeball size a few times and even experimented...
    • C
      cj133 replied to the thread Some assembly required custom DIY above ground pool build.
      • well-waiting.gif
    • C
      cj133 added the media item well-waiting.gif to General Pool Photos.
      well-waiting.gif
    Show older items
  • Loading…
  • Loading…
  • Loading…
Top Bottom