Help with Jandy Pump

[Texan2025]

Howdy

I have a separate Jandy Pump for my water feature. (Fountain)

No matter what speed I choose on AquaLink, It'll slow down quite a bit right after 3 minutes.

Any ideas? baskets, etc clean.

 

[ajw22]

Welcome to TFP.

What model number pump are we discussing?

Show us pictures of the pump and motor.

 

[Texan2025]

There you go.

 

[Texan2025]

Pic

 

[ajw22]

What speed does the pump slow to?

Sounds like the high speed is the pump priming and then it slows to a set speed.

 

[Texan2025]

That I dont know. The iAqualink shows "offline" even tho it's running

 

[ajw22]

That I dont know. The iAqualink shows "offline" even tho it's running

You need to get that working first.

What do the LEDs on the antenna show?

 

[Texan2025]

Here is the pic.

 

[ajw22]

@PoolGate @MSchutzer can you help figure out why this iAqualink is offline?

 

[PoolGate]

Show us the setup screen in Aqualink. Also how are you turning it on? It sounds to me like it is not correctly in Aqualink.

 

[Texan2025]

There you go.

 

[PoolGate]

What version is this? The newer versions you put in the pump address. Was there a screen for that? Try adding it to position 3 and 4 and see what happens.

 

[Texan2025]

I put it on 3 and it's not slowing down after 3 minutes like it used to do. THANK YOU! No errors either.
One question: How do I get rif of the air bubbles in the pump? also what is a good RPM for water fountain pump? (Now epump 3)
V 1.5 How Do I change it?

 

[PoolGate]

I put it on 3 and it's not slowing down after 3 minutes like it used to do. THANK YOU! No errors either.
One question: How do I get rif of the air bubbles in the pump? also what is a good RPM for water fountain pump? (Now epump 3)
V 1.5 How Do I change it?

Sweet! Bubbles should disappear when the pump runs at high speed. If they are not, your pump lid is probably leaking a bit. Try to lubricate the oring on the lid. That is the most common leak point.

Pump speed is per your preference on the water feature.

 

[ajw22]

Try to lubricate the oring on the lid.

Using Pool Lube - Further Reading

 

[Texan2025]

Thank you so much!!!