Anyone use a 2 1/2 coupler?
- Thread starter Bski224
- Start date
Get 2 new unions and replace both.
Use a coupling to adjust the length.
www.inyopools.com
Use a coupling to adjust the length.
Pureline Replacement 2" Union, Nut & Tail Piece, Compatible with Aquarite® - GLX-CELL-UNION - INYOPools.com
GLX-CELL-UNION - 2” UNION, NUT & TAIL PIECE (GLX-CELL-UNION)
www.inyopools.com
You can also just replace one union and adjust the other side with 2 couplings.
Is this pipe cracked?
If yes, you might need to replace the T for the flow switch as well.
Is this pipe cracked?
If yes, you might need to replace the T for the flow switch as well.
Cut out the flow switch T and the cell union and replace both.
Cut at the red line, install new union tailpiece at the green dot, install the new flow switch T at the blue dot and install another union tailpiece after the flow switch T.
Remember to install the Nut before gluing the tailpiece.
Cut at the red line, install new union tailpiece at the green dot, install the new flow switch T at the blue dot and install another union tailpiece after the flow switch T.
Remember to install the Nut before gluing the tailpiece.
Cut the pipe right at the break just before the “T”. Install a coupler right at the cut before the “T” the put my union connector for the salt cell into the coupler.
The pipe looks damaged and I am not sure that the union tailpiece will fit into the 2.5" coupling.
Also, the pipe is 2" and not 2.5".
Also, the pipe is 2" and not 2.5".
Was at a trade show when I came across this, the booth had a crowd of service tech’s purchasing them.
That is so cool! Don't think my suppliers here have them, but I'll ask.
Similar threads
