I swapped out an Ecostar for a vs and having a hard time trying to find specific schematics for connection to omnilogic. The manual shows a very different wiring setup than what I have. Before, I had a two wire connection to the eco star but now there are two insulated conductors and a shield. The manual shows all three terminating at the omnilogic but the Hua address doesn't show up in the configuration wizard. I am getting conflicting information off the internet and I haven't called hayward because the last time I called support (about 3 years ago) I was told I had to be a service tech to get the questions I had answered. Any help would be greatly appreciated. BTW, the pump runs fine in stand alone operation but when I connect the low voltage control, the vs pump controller screen will not illuminate
2.7 thp vs low voltage connection to omnilogic
- Thread starter Williamiammmm
- Start date
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Post pics of the connections you are looking at in your Omnilogic, EcoStar and Tristar pumps.
See if the pump section in here helps you- Hayward OmniLogic - Further Reading
Also see if the Tristar Technical Guide here helps - Hayward TriStar VS Pumps - Further Reading
Maybe @1poolman1 has installed these.
See if the pump section in here helps you- Hayward OmniLogic - Further Reading
Also see if the Tristar Technical Guide here helps - Hayward TriStar VS Pumps - Further Reading
Maybe @1poolman1 has installed these.
Thank you so much for your time and this info. I may just need to reset the onilogic for 15 minutes or so like it suggests. Thanks again