Latest activity Postings Media Albums About
-
-
Marina Pool and Spa came through and sent me a new motor. Arrived today and got it installed. It works as it should so far! I decided... -
Jimrahbe replied to the thread Pool Drain time again to lower CYA, Yikes!.Les, There is just no such thing as SWCG corrosion.. I have had three saltwater pools for well over 10 years and there is just zero...
-
Jimrahbe reacted to Rancho Cost-a-Lotta's post in the thread Suggestions on replacement of single speed SuperFlo 1HP with
Like.
The higher horsepower pump, in theory, will move more water more efficiently. You'll be able to run it at lower speeds then the lower... -
Jimrahbe replied to the thread IntelliCenter Program just SWG.OTC, Your SWCG gets its power from the Pump/Filter relay.. This relay only closes when in the pool mode or the spa mode. If you run a...
-
the board has a 8 wire plug, 2 for each of the relays, so I won't be able to pull it off there. That's why I wanted to secure the hot...
-
Jimrahbe replied to the thread New Pool, Easy Touch questions.Jda, You can run the pool at a low RPM, and things will still work.. You can't really run the spa at a low RPM.. This ok as you are...
-
Jimrahbe replied to the thread shocking salt water pool.hc, I suggest that you find a pool store that has a clue what they are talking about.. :mrgreen: Actually, I suggest that you...
-
If you follow TFP methods, there is no reason to shock or super-chlorinate your pool. What test kit are you using? Post a full set of...
-
There are very few reasons to step foot in a pool store, and zero reasons to ever take advice from someone who works there. If you are...
-
Jimrahbe replied to the thread AC Wire Removal.raj, Just unplug the little 2-wire cable that comes from the relay and plugs into the main card.. Just unplug it at the main card...
-
Jimrahbe replied to the thread Dolphin Diagnostics (2008) wiring repair help..G, There is no "possibly" to it. That resistor is toast!!! :mrgreen: Great job... :goodjob: Thanks, Jim R.
-
Jimrahbe replied to the thread I am not crying yet.Mc, I don't know much about above ground pools, but basically your pump is gravity fed. Water should just flow out of the pool and...
-
Jimrahbe replied to the thread Suction Side Air Leak at Base of Skimmer.Jenn, Great job so far... :goodjob: For some reason I was thinking that the PCV was glued into the bottom of the skimmer. Glad I...
-
Jimrahbe replied to the thread To drain or treat.13, If the cost of chlorine is going to be more than the cost of the water, then it only makes sense to drain and start over. Thanks...
-
Jimrahbe replied to the thread Suntouch panel and 2 speed pump.Go in and un-assign all the circuits you set up as "High Speed".. In theory the high speed relay should then not turn on.. Unless a...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…