D
Latest activity Postings Media About
-
-
DDarin replied to the thread Reduced Pump efficiency - lower variable speed Pump Flow rate.Your plumbing did not change but as PoolStored states that the height of water in your pool can and does change. (height in skimmer)...
-
DDarin replied to the thread Reduced Pump efficiency - lower variable speed Pump Flow rate.This could simply be your new watt number for operation due to you filter. Remember a slightly dirty filter works better than a...
-
DDarin replied to the thread Filter drain cap broken. How to circulate water until it is fixed.Go to the hardware store and get one of these that will fit your size.
-
-
DTry one of these for 2" pipe. You need to replumb that fitting by cutting the pipe off, removing the piece in the valve and gluing in a...
-
DDarin replied to the thread Valve or plumbing leak.I would do what 1poolman1 said. It is not hard to do and you can pick on up at any menards/lowes/home depot for cheap. Watch a youtube...
-
DDarin replied to the thread Converting fittings on above ground pool.you have no reason to increase the size of your plumbing as it is just fine. All you are doing is increasing your electrical watts for...
-
DDarin replied to the thread which pump to drain above ground pool?.siphon it out with water hose if you have elevation drop.
-
DDarin reacted to JotaDe's post in the thread Loud noise diagnosis help needed: Pentair IntelliFlo VSF with
Like.
Thank you. I do have the tool and will use it for clean up. Good idea. Got the bearings off today, front bearing doesn’t spin without... -
DDarin replied to the thread Gauge doesn’t go back to zero when turned off.its an easy trip to the hardware store plus they are cheap.
-
DDarin replied to the thread Pump Ran After Closing.Start with the seals. It is probably the only thing that needs replaced. I doubt that you created enough heat to damage any other parts...
-
DDarin replied to the thread Pump Rust Issue.Ask a lcal pool guy to save you a shroud next time he replaces a motor like that. He may even have an motor in his parts heap.
-
DDarin reacted to Dirk's post in the thread Considering a booster pump for a solar heater, I need advice with Like.
Yup, that jives with my panels' manufacturer's spec's. My panels are 12.5' x 4'. Times 0.1 = 5GPM. Times 8 panels = 40GPM total. Check...
-
DDarin replied to the thread Considering a booster pump for a solar heater, I need advice.Install a pressure gauge at your panes is the first data you need. Then go from there.
-
DDawn, If you have a SWCG you only need to run your pump at a speed that closes the flow switch and for long enough to generate the...
-
-
Loading…
-
Loading…
-
Loading…
