Minimum Flow rate for SWCG

mknauss

Mod Squad
TFP Expert
Bronze Supporter
May 3, 2014
34,763
Laughlin, NV
Your SWCG has a flow switch. When the flow through it is not sufficient, the system will indicate a warning of some type (red light, etc) that their is low or no flow. Then raise your rpm in 100 rpm steps until the light turns green, goes out, etc and the SWCG starts generating. Then add 100 rpm to provide a cushion for the filter getting dirty.
 
Thread Status
Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.