Have an old low speed in my app that I cant get rid of.
- Thread starter reelredfish
- Start date
- Jul 21, 2013
- 65,368
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Sorry yes figured folks would know that from the screenshot. Do the others look like this as well?
- Jul 21, 2013
- 65,368
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
You probably have a 2 speed relay installed that uses two AUX circuits. You need to delete the relay from the low speed AUX being used.
Maybe @PoolGate @HermanTX @MSchutzer can point you to where in iAqualink that is setup.
Maybe @PoolGate @HermanTX @MSchutzer can point you to where in iAqualink that is setup.
MSchutzer
Silver Supporter
Go into the setup system menu on the web interface and bring up the label auxiliaries page.
Here’s a picture of that page:
Re-label the auxiliary name “Low Speed” back to the default Aux name, it’s likely Aux2 as that is the one typically used for the two speed relay.
Here’s a picture of that page:
Re-label the auxiliary name “Low Speed” back to the default Aux name, it’s likely Aux2 as that is the one typically used for the two speed relay.
You may have the dipswitch #2 in the position for 2 speed pump. Need to switch it back to left side.
Ok here is mine and do not see it listed…page down does not go anywhere.
Attachments
Will check dip switch that could be the case since 23 years ago it had a two speed pump.
Thanks it was the DIP 2 have changed it and now Aux 2 shows in the place of the old low speed.
Now what do I do with aux 2????
Now what do I do with aux 2????
Nothing. Can be used if you had another device. Is your EPump connected via a RS485 cable?
Similar threads
