Automatic PH Control

delaneybob

Gold Supporter
May 22, 2021
195
Florida
Pool Size
8800
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
CircuPool RJ-60 Plus
Hi All,
The leak in the pool was fixed and my salinity is stable and PH is slowly rising over the course of a week (7.2-7.8) . Looking now to find a relatively inexpensive inline way to control PH

I don't really want a full blown automatic tester etc so much as a manual inline method of controlling PH (akin to a SWG). With the leak fixed, the chemistry is stable enough for me to manually adjust and test and then find a seasonal balance. CO2 systems seem ideal but $$$$$$

Thanks!
 
Bob,

How often do you have to add MA?

What is your TA?

Where are you trying to keep your pH?

I have seriously thought about adding an acid pump of some type, but in my case, I really only have to add a few ounces of acid about once a week. So, it does not make much financial sense.

I have found that once my TA got down to 50 or 60, I just don't seem to have much of a pH problem at all.

I do tend to keep my pH between 7.5 and 7.8.

Thanks,

Jim R.
 
  • Like
Reactions: Mdragger88
See post below for Stenner pump and tank for sale.

 
Hi Jim- My TA is 60. I have to add I would say add about 16oz of MA a week- I don't measure just know that 1 galloon lasts about 2 months
Hi Guinness- thanks for the link/sale i will look into it
 
Hi Guinness- thanks for the link/sale i will look into it
I have no dog in this hunt, but the stenner solution is a good one. You will need to do normal maintenance (clean it out, replace lines) as salts will accumulate, but it is not bad and the stenners work well.
 
16oz of 31.45% MA each week in an 8300 gallon pool with a TA of 60. In Florida so assume little or no fill water being used.

Hard to believe, but it is your pool.
 
Hi Al,l
Appreciate the input I will look into the Stenner and see if the juice is worth the squeeze to install.

thanks!
 
I have Pentair’s IntelliPH (basically a stenner pump). It’s usually sold with IntelliChem, but you don’t need it. I just bought IntelliPH, and am happy with it. It’s likely more money than a Stenner, but more plug and play. Might be worth looking into, but might not be worth the extra $ over a more DIY option.
 
Thanks. PH went from 7.2 to 7.4 in 3 days. Thus jives with what I posted I normally let it go to 7.8 before adding about 16 oz of MA to take it back down to 7.2. I want it lower so that the chances of the staining is limites
 

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.