vsf

I am a first time pool owner and have a question about the wiring and programming of my Pentair VSF filter pump with an EasyTouch system. I think my pool builder made a mistake and wired my VSF filter to the load side. This meant the pump wasn't getting power unless the filter relay was...

I just upgraded my IntelliCenter system with a Pentair 3hp variable speed pump from a single speed pump. I successfully connected the control wires to the panel. However the problem lies in a variable speed pump needs to have power all the time and right now when it calls to turn off it cuts the...

I did a whole lot of research and was going up upgrade my Aqualink to a iAqualink v3, and get a 011056 Pentair VSF pump which is apparently compatible with it. But, my installer has told me that his supplier says that Pentair's factory is shut down and that they can't get the 011056 or other...

I just got my IntelliConenct installed and commissioned - using the Pentair Home app. After some initial Wi-Fi issues (which seem to ironed out) things seem to be at least communicating. Here's the setup: - Data connection to Pentair VSF pump - Relay 1 to Polaris pump - Relay 2 to Pentair...

Hello! New pool owner and have a question. My pool has 2 Pentair VSF motors. I do see a section in the app (under pumps) to control the speed but that speed is not tied to a schedule... hence I can't configure it to run at a lower speed and speed up later during peak hours. Am I missing...

Hi Everyone, After a month of work I finally have my pool clean and I just ordered the water test kit recommended from TFP. Now I'm on the boards seeking support for maintaining the pool and have some specific questions. This year we bought all new equipment and had the following installed...

Hello Experts, Brand new pool construction completed late last week. We purchased the Pentair Intelliflo VSF pump. However, while the manual is great at teaching me how to program Speeds 1-4, I still don’t know what to do with them! 1: what does egg timer mode mean? 2: I live in crazy heat OK...

Easy Touch 4P (520591) Does anyone know how or if it is possible to connect a Pentair 3HP Intelliflo VSF pump and a 1.5HP Superflo VS to the Easy Touch control unit? Right now I have the 3HP VSF connected with the included 2 conductor com cable to the com terminal in the Easy Touch. That...