I have an inground SWG pool. I have at least 4 screws that have rusted away that hold the liner track in place, which is causing a section to droop. These screws are under the overhang of the concrete deck, so I am unsure of how to replace them. Any suggestions on how to repair this? What do these screws screw into? Could I change a section of this horizontal liner track to a vertical track? I'd like to avoid cutting into the concrete if possible.
Liner track pulling away from wall due to rusted out screws. Repair suggestions?
- Thread starter cannonj
- Start date
- Jul 21, 2013
- 65,847
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
I think it will be difficult repairing the liner track and getting the liner back up with water in the pool.
How old is the liner?
Let's see if @1poolman1 has ideas.
I think it will be difficult repairing the liner track and getting the liner back up with water in the pool.
How old is the liner?
Let's see if @1poolman1 has ideas.
Nope, sorry, there are so few vinyl pools in this area, and most liability insurance companies would cover pool service techs on the ones that are, that I have very limited experience with them. Only worked on one over 30 years ago before insurance coverage was changed. The local installer took over service on virtually all in this area.