Hello all, we have a customer with this 90 degree wedding cake corner step, unfortunately have no information regarding the original builder or pool components manufacturer. The step measures 4'9" along each wall, which would make the face of the step approximately 6' 8&1/2" (if the face was straight). I am trying to identify the manufacturer so we can provide the specs to Loop Loc for liner order. Anyone have an idea of the manufacturer? Images attached. Thanks!
Wedding Cake Corner Step
- Thread starter ODDA
- Start date
Those are new to me also! It almost looks like they are put OVER the liner instead of the liner being cut to fit. I will call a couple of people how may have input.
@ajw22 @Pool Clown @InyoRob What are your thoughts guys?
Kim:Kim:
@ajw22 @Pool Clown @InyoRob What are your thoughts guys?
Kim:Kim:
Thanks for the mentions! It actually is a standard gray step gasket/step base/step cap install with the liner being cut to it. It is a strange one. I sent it in as a 4'1" Radius with 6.33" radii, with a drawing like this, we have replaced this liner twice in the past 20'ish years for the customer, it was just a little tight when we used 4' radius measure with 6" radii measurements in the past.
Trowel some cement & V16 “cove” before first riser, per your drawing.
Plus Loop Loc is a loose cut anyway..
Plus Loop Loc is a loose cut anyway..
Ah yeah that makes sense, we will have to cove it out as you said. Thanks much!
