Wedding Cake Corner Step

ODDA

In The Industry
Nov 16, 2018
3
MINNEAPOLIS
Hello all, we have a customer with this 90 degree wedding cake corner step, unfortunately have no information regarding the original builder or pool components manufacturer. The step measures 4'9" along each wall, which would make the face of the step approximately 6' 8&1/2" (if the face was straight). I am trying to identify the manufacturer so we can provide the specs to Loop Loc for liner order. Anyone have an idea of the manufacturer? Images attached. Thanks!
 

Attachments

ODDA

In The Industry
Nov 16, 2018
3
MINNEAPOLIS
Thanks for the mentions! It actually is a standard gray step gasket/step base/step cap install with the liner being cut to it. It is a strange one. I sent it in as a 4'1" Radius with 6.33" radii, with a drawing like this, we have replaced this liner twice in the past 20'ish years for the customer, it was just a little tight when we used 4' radius measure with 6" radii measurements in the past.

97087