this was working just fine but has now ceased working. I updated the firmware on the protocol adapter successfully, installed the latest version of the software (5.2, 738) as I was running 5.2/736. I've tried unplugging power to the unit, paperclip reset on the adapter.. nothing seems to work.. when I bring up ScreenLogic it shows my system but when I attempt to open it just shows "Connecting to Pool Controller. Please Wait"
If I try and Configure ScreenLogic it just stays at "Connecting to ScreenLogic" without any further progress.
I did have a GFCI breaker trip and flipped the breakers to my pool pump and that appears to be when things started going sideways. I can enter into service mode in my ET8 and control the filter, lights, etc.. from there but no luck through the ScreenLogic windows program. similar results in the Android app that was working properly before. it shows my system but when I access it doesn't show any of my named features, pool temperature, etc..
If I try and Configure ScreenLogic it just stays at "Connecting to ScreenLogic" without any further progress.
I did have a GFCI breaker trip and flipped the breakers to my pool pump and that appears to be when things started going sideways. I can enter into service mode in my ET8 and control the filter, lights, etc.. from there but no luck through the ScreenLogic windows program. similar results in the Android app that was working properly before. it shows my system but when I access it doesn't show any of my named features, pool temperature, etc..