I got a new turbo T cell last year after the old one gave out. Everything was working well until a week ago. Omnilogic shows instant salt and average salt are both 0. I have a constant alarm that says chlorinator very low salt but I tested my salt with a salt test strip and confirmed with taylor test kit which are both showing 3500 salt. Cell voltage is showing 31 V while relay polarity is off. I just got a new T cell through warranty but the same issues persist. Could this mean issue with the board?
Salt cell showing 0 instant/average salt
- Thread starter LAKingsmike
- Start date
I got a new turbo T cell last year after the old one gave out. Everything was working well until a week ago. Omnilogic shows instant salt and average salt are both 0. I have a constant alarm that says chlorinator very low salt but I tested my salt with a salt test strip and confirmed with taylor test kit which are both showing 3500 salt. Cell voltage is showing 31 V while relay polarity is off. I just got a new T cell through warranty but the same issues persist. Could this mean issue with the board? Is there a way to manually bypass alarm?
- May 3, 2014
- 62,672
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Welcome to the forum.
Run through the diagnostics as shown in Hayward Aquarite SWG - Further Reading
Post them here.
Run through the diagnostics as shown in Hayward Aquarite SWG - Further Reading
Post them here.