I have a above ground pool and pump to filter hose started leaking thought was from heat from sun so purchased another from Amazon well this hose lewaks as well geez I wanna scream ordered another one from amazon do I need to do anything special to the fittings/hose to make water tight
Replacing filter to pump flex hose
- Thread starter Janet Chaffin
- Start date
- Jul 21, 2013
- 65,543
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Care to show us the a link to hose you ordered that you have a problem with and pics of your pool and equipment?
Care to show us the a link to hose you ordered that you have a problem with and pics of your pool and equipment?
VinnyinNJ
Bronze Supporter
- Jul 20, 2022
- 1,053
- Pool Size
- 13500
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Turbo Cell (T-CELL-5)
Like @ajw22 said, photos are helpful. If I remember correctly my last filter had orings at the filter and pump. I could never get the fitting off at the filter but removed the pump fitting every fall to store the filter. It may be bad, the new one doesn't have one, where the fitting mates to the section may be bad or it just may needed to be lubed and tightened a bit. A big Channel lock type plier works great if it needs to be tightened, just don't go too crazy. Something like this: Channellock 16-1/2 in. Tongue and Groove Slip Joint Plier 460 - The Home Depot