Latest activity Postings Media About
-
-
MITBeta reacted to Newdude's post in the thread Pool slide lost pressure after new superflo was installed with
Like.
Hey Caprica !!! I've been stewing some thoughts here since you posted and upgrading the pump would have only gotten you more... -
MITBeta replied to the thread SWG Chlorine Generation too low.Update: I ran an ONCGain test on Wednesday night with the pump on high speed. 10:39pm: 10ppm 7.5 hours @ 100% should generate 5.8ppm...
-
OK that's way better. (y) It was worth the ask as nothing else is adding up. Do the high speed overnight test and go from there.
-
MITBeta replied to the thread SWG Chlorine Generation too low.Lol. So many bubbles to worry about. My SWG is now mount horizontally and I do get a small bubble at the end of the cell, after the...
-
MITBeta replied to the thread SWG Chlorine Generation too low.I get a bubble in the pump lid when the skimmer sock is loaded up. With no resistance to suction flow, no air gets pulled in. Kids...
-
MITBeta replied to the thread SWG Chlorine Generation too low.Ah, I see what you're suggesting. Light dawns on Marblehead. I'll give that a shot tomorrow night when I have time in the morning to...
-
MITBeta replied to the thread SWG Chlorine Generation too low.I did run it all night. But I have no way of knowing whether generation stopped at any point because of low flow.
-
MITBeta replied to the thread SWG Chlorine Generation too low.I know it was in Super CL all night because I had to turn it off in the morning to allow it to mix for 20 minutes or so before testing...
-
MITBeta replied to the thread SWG Chlorine Generation too low.I wasn't able to run the ONCL test on Saturday, but I did run one last night. FC 9.5 at 10:30pm and FC 9.5 at 7:30am. Which brings me...
-
We had a similar problem with our above ground ladder. First, I will share that we aren’t particularly handy, but we do our best to...
-
MITBeta replied to the thread Pool slide lost pressure after new superflo was installed.Can you post a full picture of the equipment layout and pad? I'm assuming you know that the valve is off in the first picture above?
-
MITBeta replied to the thread Balance problem.Did you pass the ?
-
MITBeta reacted to jeffchap's post in the thread Featured Looking to take over PB doing maintenance with Like.
You cannot accurately test pH when your FC is over 10, it skews artificially high. And your FC is 41.5, which is crazy high. Are you...
-
MITBeta replied to the thread SWG Chlorine Generation too low.I appreciate everyone's responses. I would be much more likely to accept the variance from rating theory if I was measuring more like...
-
My new RJ-45+ isn't generating what it should. I just ran an Overnight Chlorine Gain Test and got less than half what I was expecting...
-
-
Loading…
-
Loading…
-
Loading…