I am new to this site and I pay a professional pool service to take care of my pool.
Our Setup
PentAir Master Temp 400 - the pool was installed in Sept 2020.
PentAir Water Pool and Spa Automation.
Salt Water Pool.
Back in Dec 2020, we set our spa (which we weren't using very often) to 101 and when we went to get in, it was at 90.
We could hear the heater cycling on and off, hot water in for a little while, then colder water.
Now May 2021:
The pool/spa heater is still not working properly. The heater itself is cycling on and off about every 55 seconds. I timed it. Consistently on and off.
The spa is taking 1.5 hours to heat up to 100 degrees. It used to take about 20 minutes.
So far replaced at 3 different service calls.
The thermal regulator $94.68 (Dec 2020)
Temp Sensor $85 (Feb 2021 – before freeze)
Replaced Air and Water Temp Sensors $98.06 (Apr 2021) *is this the same Temp Sensor?
Max-E-Therm Hi Limit Switch $80.94 (Apr 2021)
Jandy Valve Oring Kit $14.72 (Apr 2021)
Can it be water flow (or lack of) or something in circuit boards?
Any ideas?
Our Setup
PentAir Master Temp 400 - the pool was installed in Sept 2020.
PentAir Water Pool and Spa Automation.
Salt Water Pool.
Back in Dec 2020, we set our spa (which we weren't using very often) to 101 and when we went to get in, it was at 90.
We could hear the heater cycling on and off, hot water in for a little while, then colder water.
Now May 2021:
The pool/spa heater is still not working properly. The heater itself is cycling on and off about every 55 seconds. I timed it. Consistently on and off.
The spa is taking 1.5 hours to heat up to 100 degrees. It used to take about 20 minutes.
So far replaced at 3 different service calls.
The thermal regulator $94.68 (Dec 2020)
Temp Sensor $85 (Feb 2021 – before freeze)
Replaced Air and Water Temp Sensors $98.06 (Apr 2021) *is this the same Temp Sensor?
Max-E-Therm Hi Limit Switch $80.94 (Apr 2021)
Jandy Valve Oring Kit $14.72 (Apr 2021)
Can it be water flow (or lack of) or something in circuit boards?
Any ideas?