I recently cleaned the filter still the polaris filter is moving slowly. I changed the motor speed still it wont move properly. Any suggestions?
Thank You!
Thank You!
- Jul 21, 2013
- 52,486
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
The bearings in the wheels and other parts get corroded and increase friction that slow the Polaris up.
The Zodiac 9-100-9010 Factory Tune-Up Replacement Kit has the main moving parts. The Zodiac 9-100-9060 Factory Rebuild Replacement Kit has all the parts to make your 360 like new at less then half the cost.
The Zodiac 9-100-9010 Factory Tune-Up Replacement Kit has the main moving parts. The Zodiac 9-100-9060 Factory Rebuild Replacement Kit has all the parts to make your 360 like new at less then half the cost.
Thanks and I'll check but I purchased a new one last summer so I am wondering will it break in 5-6 months
- Jul 21, 2013
- 52,486
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I didn't realize your 360 is that new. The manual is here --> https://www.polarispool.com/~/media/zodiac/global/downloads/lp50.pdf?force=1
Did you test the water pressure as shown on Page 6? Page 8 - Check the wheel RPM? Check the filter screen in the Quick Disconnect and clean, if necessary.
It may be helpful for you to post your water test results from your test kit.
Did you test the water pressure as shown on Page 6? Page 8 - Check the wheel RPM? Check the filter screen in the Quick Disconnect and clean, if necessary.
It may be helpful for you to post your water test results from your test kit.
What is your water temp? When my water is below 70 it moves in weird ways because the hose to it is not flexible. When i pull mine out now the hose is “frozen” in place. If I leave it on the deck in the sun to warm up it runs normally.
its 80 degrees. I checked everything. Is it because of JAV2400 which is not in correct direction?
