Pentair Intelliflo Error Codes

[padave44]

I'm trying to find out where the error codes for my Intelliflo could be found. I'm getting F90052, and thepunp shuts off. Thanks.

 

[mknauss]

Pentair Inteliflo error code f90052

I have a Pentair Inteliflo VSP and got error code F90052 after a power outage in the neighborhood. I heard there is a way to do a factory reset. I have not been able to get it going again. It worked perfect for the last 5 years and through many rolling blackouts which are common in my area...

www.troublefreepool.com

Welcome to the forum. The above thread has some information that may help.

 

[ajw22]

Welcome to TFP.

Check the pump circuit breaker and reset it.

The manual says...

"Power Out/OFF
The incoming supply voltage is less than required."

Have you actually measured the input voltage? If your input voltage is 220 volts, then I would suspect a pump electronics failure.

You may have lost one leg of the 220V circuit which would give the pump 115V.

Pentair IntelliFlo 2 VST error codes

Hi, I installed a brand new pump. A Pentair IntelliFlo 2 VST. When I give it power I immediately get the following error: F90052 ALARM! Power Out/OFF Does anyone knows what this means? The pump is brand new and never used. Thanks --Jason

www.troublefreepool.com

Pentair Inteliflo error code f90052

I have a Pentair Inteliflo VSP and got error code F90052 after a power outage in the neighborhood. I heard there is a way to do a factory reset. I have not been able to get it going again. It worked perfect for the last 5 years and through many rolling blackouts which are common in my area...

www.troublefreepool.com

 

[Jimrahbe]

Dave,

Is your pump wired directly to a circuit breaker or is it wired to a relay or timer???

Thanks,

Jim R.