Last year - when I turned the heat on, it automatically adjusted the pump to the required pump settings. This year, and perhaps with the most recent OmniLogic update, when I turn the heat on - it will not turn the pump up automatically, it now requires me to do it manually (high/100%). I set the heater to extend, but that still isn't working. And when it hits the temperature, it won't automatically turn the pump down like it did before. I know this sounds like first world problems… I just don’t know any different and it seems awkward that I would have to either use the app or the control panel to adjust the pump and heater constantly. What to do?
Omni/Hayward Heat/Pump auto adjust isn’t working.
- Thread starter Andrewstaton
- Start date
- May 3, 2014
- 58,999
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Welcome to the forum!
Let's see if this bump finds someone with a back ground in the Omnilogic programming.
www.troublefreepool.com
I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV - Trouble Free Pool
Let's see if this bump finds someone with a back ground in the Omnilogic programming.
Hayward OmniLogic - Further Reading
www.troublefreepool.com