I’m going to document this here in a new thread so I have eyes on it.
Long story short from other thread. 1.0 loss over night test.
Suggest slam for 1 day with salt cell still on.
I didn’t have enough chlorine so I did half slam today. Level went from 14 to 8.5 from 6 am to 5 pm today.
So I have chlorine now and I have questions.
1. My cya is between 60-70. I I always er on caution to keep my chlorine up, but when I added slam chlorine now I used 60 cause I didn’t know if I could go too high and damage.
Change or let go?
2. Pump. I run 24/7 at 1600. So I now need to run higher? Right now I am. But all night?
3. Can I still use robot with high levels?
4. Salt off tonight though for over night test bit can I leave it on still in day? It’s on now.
5. Ph. I adjusted down to 7.5 like instructions say. Retested 30 mins later was 7.6. So I didn’t add anymore acid. That ok I assume?
My water is crystal clear and my cc is 0. This is what has me confused.
My only sign. I usually run cell at 33-35 percent. Have been needing to up it to 40 past few days and still loosing 1 during day.
It’s hot and 90 here right now.
Current test results:
Ph 7.6
Ta 80
Ch 350
Salt 3800
Cya 60-70
Temp 83
Fc is at slam level for 60 like I wrote above.
Added chlorine before this post.
If you guys can stick with me I would be so happy.
Long story short from other thread. 1.0 loss over night test.
Suggest slam for 1 day with salt cell still on.
I didn’t have enough chlorine so I did half slam today. Level went from 14 to 8.5 from 6 am to 5 pm today.
So I have chlorine now and I have questions.
1. My cya is between 60-70. I I always er on caution to keep my chlorine up, but when I added slam chlorine now I used 60 cause I didn’t know if I could go too high and damage.
Change or let go?
2. Pump. I run 24/7 at 1600. So I now need to run higher? Right now I am. But all night?
3. Can I still use robot with high levels?
4. Salt off tonight though for over night test bit can I leave it on still in day? It’s on now.
5. Ph. I adjusted down to 7.5 like instructions say. Retested 30 mins later was 7.6. So I didn’t add anymore acid. That ok I assume?
My water is crystal clear and my cc is 0. This is what has me confused.
My only sign. I usually run cell at 33-35 percent. Have been needing to up it to 40 past few days and still loosing 1 during day.
It’s hot and 90 here right now.
Current test results:
Ph 7.6
Ta 80
Ch 350
Salt 3800
Cya 60-70
Temp 83
Fc is at slam level for 60 like I wrote above.
Added chlorine before this post.
If you guys can stick with me I would be so happy.