Latest activity Postings Media About
-
-
DavidArmenB replied to the thread Replacement Actuator (Pentair vs. Tork) - Quality Difference?.I have two and have not noticed any differences on the insides. Same AC motor, same type of switches. Electrically, only two things can... -
-
-
DavidArmenB replied to the thread Three way PVC ball valves.Is this something you made or is there some type of guide you followed to achieve timed valve positioning in addition to the two...
-
m, What did you buy? Was it a Jandy three way valve? Not sure what restrictions you are talking about and how they would have any...
-
DavidArmenB replied to the thread PB installed elbow right before pump inlet.This is actually a very good question because I, too, know about the rule that the pipe entering the pump needs to be five times as long...
-
DavidArmenB replied to the thread Thought: Delayed activation of Heater Bypass.Since the automation systems do not have features like this, I have connected my valve actuators to a wifi relay so I can set everything...
-
This is what I use to snug up the plug. I can get about 500 foot-pounds of torque. Guaranteed no leaks. GBOGH...
-
I’m not exactly sure why everyone thinks you need to use a wrench on that plug. I hand tighten my plug and give it a very light “snug”...
-
DavidArmenB replied to the thread Looking to help bypass the Thermeau heater.+1 on the three way valve and check valve method.
-
DavidArmenB reacted to ajw22's post in the thread Looking to help bypass the Thermeau heater with
Like.
One 3-way valve on the heater input and a check valve on the heater output will give you a foolproof bypass. Read Heater Bypass -... -
DavidArmenB replied to the thread Need new pump and SWG. Sizing question and CircuPool feedback ?.+1 Nothing better than a 3HP pump running at 1000-1200rpm, pumping over 20GPM, and consuming only 100W. Switching from a 1HP/1.5HP SS...
-
DavidArmenB reacted to 1poolman1's post in the thread Need new pump and SWG. Sizing question and CircuPool feedback ? with Like.
If you go that route, get the 3hp pump and run it slower for the best energy savings.
-
DavidArmenB replied to the thread Rust inside my Jandy DE Filter.As members stated above, this is very common and not just for Jandy. In fact i am sure this issue is more documented for Pentair...
-
DavidArmenB replied to the thread Pentair check valve flaps “dissolving”. Is this a common problem?.This doesn’t answer your original question but chlorinating with a SWCG when the pool has a CYA concentration of 70ppm requires you to...
-
If the fittings are coming apart, you are doing something wrong. The pump cannot produce enough pressure to separate properly glued...
-
-
Loading…
-
Loading…
-
Loading…
