I reprogrammed my RS8 about two weeks ago after I found out that I’ve been running 24 hours a day and seven days a week. I’ve noticed that the low speed pump won’t turn on. The current programming is for the high-speed pump to run from 7 AM to 6 PM. And I had a low-speed running from 6 PM to 10 PM. The high-speed is running fine and at 6 o’clock it turns off but the low-speed does not turn on. I’ve gone in and tried to reprogram it again and even set the low-speed to turn on at 5:59 PM and once I do that and hit enter it shows it’s working and will prime the high-speed pump and the low-speed will take over and run to the designated point. But then I go back today on the low-speed should be on and it’s not. I’m open to any suggestions