I have a Jandy RS4 control board that went out. Due to this board no longer being made which I am sure most of you know. My questions is can I upgrade to a RS8 but just swapping it out or is there something else I need to be aware of?
Jandy RS4 to RS8
- Thread starter JohnPG
- Start date
- Jul 21, 2013
- 52,748
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Yes, you can install the RS8 board in your RS4 system.
Do you have iAqualink?
The best way to get an RS8 board may be with the IQ30-RS upgrade kit.
www.troublefreepool.com
Yes, you can install the RS8 board in your RS4 system.
Do you have iAqualink?
The best way to get an RS8 board may be with the IQ30-RS upgrade kit.
Jandy iAquaLink 3.0 Web Connect Device
#IQ30-RS iAquaLink Web Connect Device Kit
www.tcpoolequipment.com
Jandy Aqualink RS - Further Reading
www.troublefreepool.com
A few screws, a few plugs and its out. Reverse and the new board is in. Will require new programming.
- Jul 21, 2013
- 52,748
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
So is the program on the RS4/6/8 board or is it part of the wireless add-on? Assuming its the former which if it is, is the easiest way to do this by basically documenting every page in the web portal and recreating it on the new board?
- Jul 21, 2013
- 52,748
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
All the Aqualink programming is on the board. You need to go through the screens and write down or take pictures of the settings.
No, but an RS4 probably didn't have too much programming to begin with.
