Jandy Lite2 Heater - Increase temp button broken

familytr33

Bronze Supporter
Apr 4, 2016
81
South East USA
Hi,

On my Jandy Lite2 control panel the 'increase temp' button does not work.

I can reduce the temp, but not increase it, and all the other buttons seem to work.

Right now the set temp is 74 and I can't make it go higher.

I did just find that the manual states that all settings can be reset by holding the ENTER button for 7 secs. Default factory pool temp is 80 degrees. I will try this at lunchtime.

But... anybody know if the button can be fixed without replacing the controller?

Thanks,

ft.


--- TFP Supporter status submitted ---
 

ps0303

TFP Expert
In The Industry
Jul 6, 2011
4,029
FL
It's a pretty typical issue where the sun/weather kills the keypad. You will need to replace it.