So opening the pool today and the heater LED lights come on but won't display anything on screen nor does it fire up. Anybody can help trouble shoot this with me? Thanks in advance
Jandy JXI400N Heater not displaying
- Thread starter Maxtcee
- Start date
- Jul 21, 2013
- 55,440
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Is the heater controlled by automation?
See if the Troubleshooting on page 24 helps — https://www.doheny.com/media/Pdfs/7609-instructions.pdf
Could be a bad User Interface board.
See if the Troubleshooting on page 24 helps — https://www.doheny.com/media/Pdfs/7609-instructions.pdf
Could be a bad User Interface board.
I'm not sure what you mean by automation. I'm using the two wire setup. The unit is only 4 years old. The lights come on but the display does not show anything and it does not fire up. Do you think it's still in the warranty?
- Jul 21, 2013
- 55,440
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- Jul 21, 2013
- 55,440
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Have you opened up the heater and checked that the wires to the User Interface are not loose?
Just opened up the heater and the iaqua panel and all wiring seems tightly connected. Going to try jandy when they open
