I Have an IC40 that has a low salt reading of 2500, but salt level is actually 3600, and it does not seem to be producing chlorine. When I hold down the "more" button for 3 seconds the "Cell" and "cold water - system off" lights come on (cell=green, cold water=red) both solid, then the cold water flashes red.
Does the flashing red cold water light mean my temp sensor is bad?
Also the calibration process does not let me cycle through the salt levels, perhaps because it's to old/new of a version. The sticker on the bottom of the unit says Rev 3050.
Does the flashing red cold water light mean my temp sensor is bad?
Also the calibration process does not let me cycle through the salt levels, perhaps because it's to old/new of a version. The sticker on the bottom of the unit says Rev 3050.