I just got a new salt cell and when I went to use it. the system started generating then the check salt and inspect cell lights come on and it won’t let me change the cell type it just stops at the Circuit board revision screen. I’m thinking it being the wrong cell is the problem why it’s not generating.
Hayward Aqua Rite system won’t let me change the cell type. Help!!
- Thread starter Ethan2003
- Start date
- Report all readings when you..
- Move the switch from auto to off and check all of the readings.
- Move the switch back to auto and recheck the readings.
- Move the switch to off for a minute and then back to auto and recheck the readings.
- What are the first seven characters of the cell and box serial numbers?
- What is the actual salinity and how are you measuring it?
What cell did you get?
Can you show a picture of the circuit board (the entire main board)?
Pressing the diagnostic button sequentially will display:
- Default salt display
- Pool temp
- Cell Voltage - When not generating, the voltage is about 30 to 32 volts dc. When generating, the voltage drops about 1 volt per amp of current.
- Cell current
- Desired output (% of the knob)
- Instant salinity
- Product name
- Software revision (r.XX)
- Cell type
Hayward Aquarite SWG - Further Reading
www.troublefreepool.com