Pentair IC-60 is showing a red light on the flow indicator. Also showing I need to add salt. My easy touch controller shows i have 2550 ppm and a manual test shows I have around 32-3300 ppm. Water temp about 65 degrees.
I cleaned my cartridge filter system out at lunch today and it was dirty but it did not help the problem. I have an old IC-40 with a new flow switch in it that I tried when that cell went bad that I might be able to swap out and try. These dang SWGs are like $1000 so I would like to try whatever I can before I buy a new one.
Question is what would you do to troubleshoot this situation?
I cleaned my cartridge filter system out at lunch today and it was dirty but it did not help the problem. I have an old IC-40 with a new flow switch in it that I tried when that cell went bad that I might be able to swap out and try. These dang SWGs are like $1000 so I would like to try whatever I can before I buy a new one.
Question is what would you do to troubleshoot this situation?