Aquacal Pool Pilot Nano - Warning, no output, what to check?

[piefightclub]

Hello folks,
New to the forum, looking forward to becoming more self sufficient when it comes to maintaining my pool.

I'm having a problem with my Aquacal Pool Pilot Nano. I'm having the dreaded "Warning! Low Amps: Cell?" message, If it do a "Test Pool Pilot", I get "Cell = 3V and .2 A". I've cleaned the Cell, checked the fuse, and checked power into and our of the linear transformer (121 Vac in, 13.75 Vac out on both coils)

Any guidance on what else I can check here?

Thanks!

 

[mknauss]

Welcome to the forum!

AutoPilot SWG - Further Reading

www.troublefreepool.com

Review the above article for some troubleshooting tips.
I suggest you read ABC's of Pool Water Chemistry.

 

[piefightclub]

OK, after going back out to check on it, it now show 31V, 1 Amp. Testing voltage at the salt cell end of the cable shows 35V. The cell has nearly 40,000 amp hours on it, not sure if that's good or bad. I'll try cleaning it again.