Search results

  1. melsteph

    Rusty Furniture Flakes?? . . . Rust Stains on Pool Sun Deck

    Hi Y'all! Let me first say I DID NOT have patio furniture in the water or even too close. Two things happened early spring: I noticed staining on my sun deck ledge but thought it might be from red dirt or possibly algae. I knew to slam the pool coming out of winter to do a good cleaning and...
  2. melsteph

    Sealer for coping and decking

    Need current thoughts on resealing our flagstone coping with the stained concrete decking. It is a three year old pool and was sealed by pool builder. We'd like to do it ourself if possible. Is it the same sealer for both surfaces? Thanks as always and Happy Summer! Melissa
  3. melsteph

    Another Year to Do Better!

    I LOVE this site and tell every pool owner I know about it! Each year I try some new product that is recommended here or try a method to make my pool life better. I say all that to say TA/pH is going to be my focused goal this summer. It always runs high. High pH, add Muriatic acid, raise...
  4. melsteph

    Coupon Code

    Is the coupon code good each year for TFTest kits or just a one time use? Thanks! M
  5. melsteph

    Freezing in Texas

    Right now we've been below freezing 36 hours or so. Several days still to go. Water is circulating with the freeze protection and I have it set to be on 24/7 as a backup. I didn't "close" or winterize because - it's Texas. So here I am. Thoughts on what to do if or when we lose power? I'm trying...
  6. melsteph

    It's HOT! What do you think?

    Hi Guys! Pool is BEAUTIFUL. Warm but beautiful! After researching on here I turned on the misters, fountains and waterfall during the night and most of the day to keep it around 90 degrees. Feels pretty nice early in the day. Pump/SWG at 80% of day. Here are my levels today: FC - 2 pH - 8...
  7. melsteph

    Headed to Pool Store! Help

    Here are my readings: C - 3.4 pH - 7.8 CH - 330 TA - 100 CYA - 70 Temp - 86 Rust spots are not coming up with muriatic acid soak (pool builders suggestion to try). I am worried it is rebar in a one year old pool!!! Pool builder/store says that is "highly unlikely" and I probably have a metal...
  8. melsteph

    RUST Spots? Something else??

    Hi! Today is the one year anniversary of our IG pool!!! I thought we were still in the honeymoon phase, but these rust spots are causing me to panic and think the worst! Help and advice needed. Melissa
  9. melsteph

    HAPPY MEMORIAL DAY WEEKEND!!! & Questions ;)

    Pool is looking awesome! I love my Speedstirer thingy! Thanks for the tip there! New reagents and here are todays #'s: ph - 8 (likes to run a little high, I know to add MA) FC - 1.4 (running SWG at 80% for 6 hours) Hasn't been too hot in Texas yet. *** TA - 90 CH - 320 CYA - 70 Temp 80 ...
  10. melsteph

    Texas Winter with the Pool

    Hi! I have missed you guys but didn't need much during the winter! I followed your advice on not "closing" in Texas and the pool has looked fabulous all winter! I am so ready to be back in it! The picture shows you two things - the water clarity coming out of winter and my missing drain...
  11. melsteph

    Fall Pool Conditions

    Good Morning! Here are my test results this week. We've had some rain, much cooler temperatures, and I am running my pump less now also. Pool still looks clear and amazing but want your thoughts on my levels. Specifically - 1. Why is my pH ALWAYS high within a day or so? 2. Do I need to...
  12. melsteph

    To Close OR Not To Close??? I have questions!

    Good Morning- Fall has made its first arrival in Texas and I know my pool days are probably over for a few months. New IG pool, we do have automatic freeze protection, and I dont think we will cover. We live on top of a hill with no close trees or deciduous shrubbery. So what are my options...
  13. melsteph

    Tinge of Green...

    I noticed today my pool has a tinge of green look about it. Tested this afternoon: FC 1 pH - 8+ TA - 220 CH - 240 CYA - 40 ish salt - 1400 low salt error came on today CSI when calculated says 1.17 I am turning off all water features. I have had them running during the day. We also just...
  14. melsteph

    Upcoming Long Weekend

    Hi Guys! We just had our first measurable rain in about a month, so I tested everything tonight to see where I was after the additional water. TC - 6.6 pH - 8 (Will add MA) TA - 70 CH - 220 CYA - 60 CYA was such as issue for me early after the build, so I am hesitant to add anything. Tell me...
  15. melsteph

    How do I look??

    I am so excited! FINALLY my CYA is down! THANK YOU THANK YOU THANK YOU! Here were my results: FC - 4 pH - 7.6 TA - 110 CH - 220 CYA - 80!!!!! QUESTION: My SWG is running at 40%. Do I need to bump it up to take care of FC or add bleach? See any other issues???? I am adding muriatic acid...
  16. melsteph

    Water Exchange/CYA Question

    Over the past 24 hours I have replaced about 12 inches of water in my pool (not sure how else to give a measurement). Pool is full and as expected all levels are now off. I read where to get my CYA in check then rebalance, correct? My question is - Does the CYA drop over time with the water...
  17. melsteph

    Same Reagent???

    Are these the same??? Small one came in new kit, needed refill. Pool store said the large bottle was the same. If it is my chlorine is so high it's unreadable. M
  18. melsteph

    About to drain on a new pool! :(

    with SWG FC 3-5 (See chart) pH 7.2-7.8 TA 60-80 CH 350-450 CYA 70-80 CYA is still running about 180. I'm so nervous about draining on a new pool. Here are today's results. I assume I don'tdo anything else until I exchange water. FC- 13 pH - 7.8 TA - 90 CH - 200 CYA - 180 (dilution test) Water...
  19. melsteph

    Pool Store Comparison

    AHHHHH!!!! I am still monitoring CYA and ran out of the reagant. Thought I would test everything else, take sample to pool store to compare my results, AND let them test CYA until my reagant arrives (or buy there). My results with new Taylor K-2006 are on left. They used sticks and a Taylor...
  20. melsteph

    Week One with SWG

    I am at the end of my new pool maintanence and ready to do this myself. New kit is ordered but I did use my old one (intex pool last year) to check results. Salt was low on the new SWG indicator so went to pool store and had them also test. I have added more salt. Here's what they said: FC -...
  21. melsteph

    "Old" Pool Math Calculator?

    Is there a link to the "old" pool math calculator still? I liked seeing everything on my computer rather than the phone. (old eyes) :) Melissa
  22. melsteph

    New Pool + Pool Company Management = confusion

    Hi All and Happy Summer! I have new IG pool and part of our contract had that the pool company would "manage" it for the first month. That part hasn't been great - but we are about finished with that timeframe. Yesterday (7/1) I made sure I was home and outside when they came so I could see...
  23. melsteph

    New IG - Salt System or leave only Chlorine?

    We are closing in on day 28 - the day they said necessary for curing in order to install cleaner and saltwater system. We ordered and planned for the Intellichlor 40 SWG system, but now the contractor seems to want to talk us out of it. He claims we will not like it due to the flagstone we...
  24. melsteph

    EXCITED!!!! BUILDING IN GROUND POOL!!

    I have been a follower here for years and have loved taking care of allmy Intex pools through the years with guidance and lessons learned HERE! We are now building our in ground pool! My question is based on Intex pools, TFP lessons, and past experiences. 1. Can I be successful mainitaing an...
  25. melsteph

    SWG Scaling

    I am having to clean off the plates every 36-48 HOURS. SWG is NOT producing or helping maintain the chlorine levels for this heat. Algae gone, done with slamming, but might as well unplug SWG and go straight chlorine chemical pool! UGH Test results past two days: What am I missing? TC - 2...
  26. melsteph

    Came Home to SWAMP

    Hi! This is the first year I have not emptied and started over with water in my AG Intex pool. I thought I would try to save it and follow all the opening protocals. It was horrible after the winter and took a full month to be even cloudy and somewhat clear. I had finally got it sparkly and...
  27. melsteph

    Water Balance!

    HI! I have been monitoring and testing water for a few weeks now. Ordered new regents and tested again last night. I run the pump/filter/SWG a couple of hours a day right now. Here is what I got yesterday- pH - 8+ CH- 3 CYA - 60 TA - 100 CA - 40 Water is clear. I have an intex metal frame...
  28. melsteph

    Starting over

    I took the pool down last fall to level and start new this spring. Have filled it up, added some bleach for algae in bottom, and muriatic acid because I knew I would need it. Tested today and here are readings: Chlorine - 0 PH - 7.4 Alkalinity - 330 CH - 25-50 CYA - 0 I put that into pool math...
  29. melsteph

    constantly adding acid

    Hi! I am fighting a high pH/high TA problem with my AG pool. I add acid about every 2-3 days to keep it in the 7.5-7.8 range. Even after kids swim and pump is on for hours, the TA is at 200. At what point do I add stabilizer to these numbers and am I going to fight the high pH all summer...
  30. melsteph

    New to Pool Test Kit

    Hi! Just want to say I LOVE this site. Have had 4 Intex pools through the years and relied on your site for lots of advice. Have never posted until now. I have an 24' X 52" AG Intex pool with sand pump and SWG - All new this year. I have had the same set up for the past three years, but...