Search results

I'm not a chemist but I did have a similar question to the original post. When you add HCl to your pool, my understanding is, the H side reacts with the carbonates in the water to form Carbonic Acid. So where does the Cl side go?

Yes, I have the versaflow and thought it was a complete bypass. Good to know there is some water movement.

My main concern is with the heater since water does not run through it unless the heater is on. Should I drain it or set it to heat the pool a couple degrees hotter than freezing?

Forgetting to order the tile or dig the gas trench are problems we had with our build too. Those are the most annoying delays because they are completely avoidable. Your tile does look just like mine too.

Same for me. In my opinion my installers over did the acid wash so it is more rough than we expected, especially in the hot tub seating area where you are sitting on it. I think this is an installation issue though and think it is fine otherwise. We were going with NPT Stonescapes Mini-pebble...

I plan to eventually add Borates but will wait until my plaster is at least a year old based on the discussion here and elsewhere. It just seems, anecdotally at least, that having mature plaster is the prudent approach.

Hilarious story. Sorry I saw this so late but you need to call up Jase Robertson.

I want to see how that faux edge looks when you are done. Our designer tried to sell us on that but I vetoed it and went with the coping edge on the back side.

What about the CH? This is a new pool we only put water in it July 28. Two and a half months ago. Should I raise it? We have hard fill water from a limestone bottom lake so I’m surprised it is not higher but we have had a lot of rain and had it to the top of the coping a few times from rain.

It is a Lesli's Total Poolcare DPD Test Kit 18-576 it is made by Taylor and has all Taylor reagents. It tests for everything the K2005 test has (Free & Total Chlorine or Bromide, pH, acid & Base Demand, TA, CH, CYA) Only difference I see is the box shape and the sample tube shape. I have a...

ok, two days in a row with the Taylor kit. My pH and Chlorine are stable (cloudy days). If I look at this I think I need to add stabilizer to get into the 70-80 range. Then just monitor. I think my FC will come down when the clouds part. I have adjusted the generator down some since the...

I'm a newbie but I just went through this a few weeks ago so here is what worked for me. 1. Know your pool capacity and how much salt is in it now. For me it was 18,500 gal and 390 ppm salt. I used an electronic salt tester that I calibrated using a known test sample. 2. I guessed based on...

Just a shot but Is this solar heater the kind that you pump the water to the panels, raised up and maybe on the roof? Is the SWG before or after the heater in the lines? If the SWG is not the last thing before the returns then maybe your chlorine is staying in the solar heater?

ok, Just tested TA with a different (New) test kit and it came out to 90 and that is closer to the 80-100 that I see with test strips so I think I have a bad old kit. Is that possible? The new test is a Taylor and turns Green to Red. The old one is OREQ (came from PB) and goes blue to yellow...

Apparently they do an adjusted TA number based on CYA and pH so I should not have used that number to calculate the CSI

Latest test results from Leslie Pools top, my test from 2 days ago on bottom. We had some tile repairs done Monday and they used some Acid to wash the patch, I don't know how much they added. I also broke down the filter and cleaned it for the first time since construction. A white mark on...

I've been using 1200 RPM as a low mode in my pool. I do not find it moves much water to the skimmer at that rate. I may need to balance my main drain and skimmer lines a little better.

your coping and tile look like mine. You should love it.

Back to the parallel vs Series question. Would it make sense to have one SWG tied to each of the two filtration pumps (parallel) since it has to be the last thing before the returns. If you go series you would have one pump filtering but not sanitizing and the other pump filtering with double...

There are a few other factors for the equation like the incremental electricity for the SWG and bags of salt but they don't change the outcome that the ROI is better with the SWG.

Just subscribed to the Pool Math App - You should see the link Have most of my levels in line with a few exceptions (see below) Set up my SWG at 50% with the pump flowing 24hrs and staying in between 4-6 ppm Free Chlorine Bought a FAS DPD test for chlorine Learned that 40# of salt raises my...

Night picture with new lamps. Almost done.

My IQ Alpha + just got dropped off by the pool builder today. I will add more once it has run a week.

I forgot to add that it came out to 18,500 gallons

9/22/20 Contract Signed 12/9/20 Excavation (6 days after permit) 7/27/21 Water fill We are still working on getting utility ditch filled and stone work around patio completed as punch list items.