Recent content by scm175

Test results before I began the SLAM were FC 0 PH 7.8 TA 110 CH 70 CYA 50 I added 136oz of #10 liquid chlorine. Just woke up and will test again soon. Pool still looks the same, light green.

Began a SLAM tonight. I I added muramic acid to bring my PH down to 7.2 and added liquid chlorine to bring my FC up to 20 (CYA is 50). As I was putting everything away I glanced at my bottle of acid and realized it is 31.45% instead of the 15.7% in usually use. Pool Math says that much acid...

I live in PA and spent 3 weeks trying to find an Intex pool with no luck. I finaly found one in NC not far from my parents house so we took a road trip. My mom was glad to see us but she thought I was nuts.

How far out of level is the existing gravel pad? Compacted gravel can make a good base for your pool if it's level and you use something like rigid foam to protect the pool floor.

I would recommend going with standard pool fittings and plumbing your pool with 1.5 inch pvc. There are several threads in here about how to do it.

I have never had an issue with the ladder damaging the liner. Those liners are pretty tough, They do make ladder pads like this one if you wanted to add one,

Another vote for the frame around the pool. Use PT 4x4 and make it one foot larger than your pool.

I would use rigid foam insulation between the road base and the pool. Something like this.

How far out of level is your site? Paver base will compact very well but will be unstable if the base is too deep.

If the diameter of your round skimmer hole will fit in the square opening of a new skimmer then you should be good to go. That's how I did mine a few years ago.

I replaced my factory summer waves skimmer with this one. then use this adapter to hook it up to your filter Here is a post on how to install the skimmer. The factory skimmer doesn't flow enough water to supply the larger pumps and the best solution is to remove it.

I would get rid of the 1.25 inch hoses, they really restrict water flow. Is there a intex return fitting on the end of that plunger valve in the picture? If there is you can use that. You will need to trim your liner a bit to make it fit.

I never use the boost feature on my SWG. I fill the pool and start the pump. Add the proper amount of liquid chlorine to bring up my FC level and add the salt. Brush the salt around until it is fully dissolved. Let the pump run and start the SWG the next day. You can do your cya test as soon...

You can add some DE to your sand filter. Search pool school for instructions on how to do it.

Make sure the o-ring on the pump didn't roll out of place. If that's not it try replacing the plastic clamp with a metal hose clamp.