Recent content by ps0303

Most likely you have a bad display module. However, depending on where you live, it could be a tree frog that go in where the board is and got fried. I would remove the board and look at it and if you see signs on a frog dead on the board, you might need a new board which comes with a new...

Out of curiosity, why are you considering the Ultratemp ETi hybrid heater?

Yup I see this a lot here in Florida. Use some duct tape to cover the holes that allow the critters to inside where the board is located. Also, Raypak does have a foam piece that they gave some installers and it goes between the board and the bezel to protect it. You'll have to call them for the...

Make sure that you are noting having an issue with your automation temp sensor. People tend to overlook that and think it's a heater problem. So look to see what the automation says your current water temp is. Also, you need to check for continuity on the wire between the heater and the...

To run that heater efficiently, you really need to have the pump speed higher. 2700 - 3000 rpm while the heater is in use per the manufacturer. Filter cartridges should be cleaned once a month or so. Do not rely upon your filters pressure gauge to tell you that the filter needs to be cleaned...

You'll also need to convert the gas valve or get one that is set up for propane.

Well if Pentair diagnostic says "replace board", then replace the board. Try not to over think things.

Bad blower motor or bad run start capacitor if so equipped. Post a picture of the motor.

This is an informational post. What can happen if a pressure relieve valve fails? This will happen.

Yes put the heat pump before the gas heater.

If the gas valve is working, you should smell gas when it opens and tries to light. If you don't smell gas, you have a gas flow issue.

Yup I see the frogs here in Florida on many of the Raypak/Rheem boards. Raypak did come out with a high density foam panel that you can sandwich between the board and the bezel to keep these frogs out. Alternatively you can use some good duct tape and cover over all the holes inside the unit...

Pool leaks can drive you crazy. Spend the money and hire a leak detection company to come out and do a complete run thru of your system. It is well worth the price of admission. I know this from personal experience and I'm in the pool business.

Companies are tired of wasting time and money for DIY installs. BTW, I wouldn't be surprised if more companies stop allowing their units to be sold on the internet. It's not like buying a refrigerator and plugging it in to power. I can't begin to tell you the number of times a homeowner...

birdman579 You need to put mesh wire over the vents on this unit to keep the mice out. There is a company that sells pre-cut mesh panels exactly fort his heater. I am not associated with the company, Products | MK Rat Proofing, that makes them but I have used them on several of my customers...