Recent content by Georgia_Pool

Anyone have any thoughts on this? Thanks!

Hi! Has anyone had an issue where the water temperature on the ScreenLogic app shows a number that is way off the mark? Sometimes I open my app and my water temperature shows 39 or 40°, then a few minutes later it corrects itself to the actual 84 or 85° temperature the water truly is. This...

Actually, I just noticed when it turns off the red service heater light illuminates. Any thoughts on what could be going on? The heater is only one year old.

I have a one year old pool with a Pentair Mastertemp 400 natural gas heater. When I am heating the pool, I’ve noticed the heater cycles on and off periodically before the thermostat setting is satisfied. Is there some sort of safety feature that only allows it to run for so long or reach some...

Thanks guys!

This is the first winter since our pool was installed. Since the water temperature dropped through the 50s, the Pentair SCG has been in cold water cut off mode. Last time I checked it, the water still had an adequate level of chlorine present, but I assume it will get low at some point. Should I...

Aside from once right after they filled the pool, I have never added soda ash or baking soda to my water. My pH level is always correct or a little high, so all I have added is muriatic acid as necessary to bring the pH back down. The pool was filled on May 3, so it’s a little over three months...

The pool is new this year, filled with water on 3 May 2019. I have a Dolphin robotic vacuum and still have pebbles shedding and being sucked into it each time I run it.

Hi, I have an IG 22,000 gal. pool with NPT StoneScapes mini pebble plaster finish. Are wire brushes safe to use on this mini pebble finish, or should I stick with nylon? This product looks pretty cool, anyone tried it or have another favorite brush you would recommend? Thanks!

Around 21,000-22,000 gallons. I would be ok with 50-80 PPM.

Is this stuff difficult to dissolve? It says pour directly in skimmer, but last time I did that with a CYA product, it clogged my skimmer...and I didn't even pour very much in there.

Thanks jblizzle. Could you offer a “best product for the price” suggestion that I can order online? I don’t like to shop retail pool stores where markups are really high. Thanks!

Hi, Any opinions on this product? It is advertised as a good alternative to the normal cyanuric acid stabilizer products. Thanks! Georgia Pool

Yes, that’s typically what I see as well. I was having a hard time finding a couple of the GFCI’s I needed for outside, and cost was going to be significantly more with buying several GFCI’s for outside vice a single one inside. As always, thanks for your (and everyone else’s) replies!