First off - awesome site and forum! Thanks for sharing knowledge!
I have a Lifesmart LX200DX 110 volt spa (approximately 6 years) It uses a heat recovery system which (as I understand it) uses pump friction to heat the 200 gallons. It will work for a few days with no problem at 104 with the pump running to heat and I have it set to circulate for 30 mins every 12 hours. It runs much more than that to keep the temp at 104.
It will sometimes continue to run and OH up to about 118 degrees. I'll let it cool down and it will work fine again for a few days. I've checked with a thermometer and the temp is accurate - not sure if should look at replacing the board or the hi temp limit sensor. I'm handy enough to mess stuff up, but not get hurt LOL. I also like to do stuff myself, but don't feel very comfortable troubleshooting the guts of a circuit board. The source of all knowlde shows the board to be a Gecko IN.YJ2 heat recovery system. Any idea where to start and any help is appreciated!
Thanks for the site and sharing info
Matumba
I have a Lifesmart LX200DX 110 volt spa (approximately 6 years) It uses a heat recovery system which (as I understand it) uses pump friction to heat the 200 gallons. It will work for a few days with no problem at 104 with the pump running to heat and I have it set to circulate for 30 mins every 12 hours. It runs much more than that to keep the temp at 104.
It will sometimes continue to run and OH up to about 118 degrees. I'll let it cool down and it will work fine again for a few days. I've checked with a thermometer and the temp is accurate - not sure if should look at replacing the board or the hi temp limit sensor. I'm handy enough to mess stuff up, but not get hurt LOL. I also like to do stuff myself, but don't feel very comfortable troubleshooting the guts of a circuit board. The source of all knowlde shows the board to be a Gecko IN.YJ2 heat recovery system. Any idea where to start and any help is appreciated!
Thanks for the site and sharing info
Matumba