The pool install process has made significant progress over two full days. It was significantly more expensive than expected, but the problems were far greater than imagined. At one point i almost wondered if i should go in-ground with how much work they had put in. I found a fiberglass shell with tanning ledge for a pretty good price and then they hit actual ledge... So back to an AGP. Pictures to follow for sure.
Question now that the Pump and Filter are set. I purchased two "slice valves" from The Pool Factory which wont be used. Is it possible to use one of these on the drain of the filter to facilitate attaching a line to redirect the water output?
Question now that the Pump and Filter are set. I purchased two "slice valves" from The Pool Factory which wont be used. Is it possible to use one of these on the drain of the filter to facilitate attaching a line to redirect the water output?