Hello, I have a pool and spa with a pentair easy touch controller and ScreenLogic iPhone app. I had to shut off the main power breaker to the entire system for 24 hours to relocate the pool sweep and waterfall pumps. After completing this Work, the two automatic valves that control the pool, spa, and sweep are no longer programmed correctly. Now, when I switch on the pool pump all flow goes through the spa And not the pool. If I try to run the sweep the valve does not open to allow any flow through the sweep pump. I did not change anything that controls these valves while working on the pumps. Did shutting off the power erase the valve programming? Is there a simple fix for this, or do I need to reprogram the valves? My pool is three years old and was programmed by the installer, so I‘m not sure how it was done in the first place. Thanks for any help or suggestions. Mike.