My pool was complete in August of last year and i took over my pool's balancing. I still have almost a full tub full of 3"jumbo tabs from leslie's Pool that i place into a feeder. Once these are gone, i would like to use liquid chlorine but not sure how to go about that, i'll dig into that some more by going through posts on here and looking over Pool School some more. It has been raining on/off here in North Texas and i just got back in town, my water is kinda dull and i cant see the bottom on the deep end. I'm using the TFT-100 kit and below are my readings from today.
CL-5
Br-10
PH-8.2
FC-5ppm
CH-225
TA-130
CYA-20
My PH has always been high when checked since the pool was installed, usually around 8.0. After looking over pool school, i did notice it mentioned that i could have a high PH for a while with new plaster for the first 6 months. I think the numbers i have are pretty close to what is recommended, can someone provide some info on what i need to add to balance this out and get my water looking clear again . Is a using a Clarifier or PH reducer like they sell at Home Depot a good idea? Thank you all for your help!
CL-5
Br-10
PH-8.2
FC-5ppm
CH-225
TA-130
CYA-20
My PH has always been high when checked since the pool was installed, usually around 8.0. After looking over pool school, i did notice it mentioned that i could have a high PH for a while with new plaster for the first 6 months. I think the numbers i have are pretty close to what is recommended, can someone provide some info on what i need to add to balance this out and get my water looking clear again . Is a using a Clarifier or PH reducer like they sell at Home Depot a good idea? Thank you all for your help!