I got a saltwater pool/spa installed 3 years ago with all hayward components and omnilogic control system.
Since day 1 the temperature readout in the omni logic has been a little off and especially noticeable when using the spa.
It has gone from maybe 2-3 degrees off to now maybe 20 degrees off.
This is quite annoying when you get ready to jump in the spa and it is lava hot.
I believe there is a temperature sensor in the heater and another in the saltwater chlorinator.
I assume the temperature sensor is bad and was going to change it out, but not sure which one is in control for the heater.
Since day 1 the temperature readout in the omni logic has been a little off and especially noticeable when using the spa.
It has gone from maybe 2-3 degrees off to now maybe 20 degrees off.
This is quite annoying when you get ready to jump in the spa and it is lava hot.
I believe there is a temperature sensor in the heater and another in the saltwater chlorinator.
I assume the temperature sensor is bad and was going to change it out, but not sure which one is in control for the heater.