Temp Sensor

[SMICON]

I have a Hayward Omni PL and getting the attached messages...

 

[ajw22]

Check the temperature sensor connection and wire and replace it if necessary.

 

[SMICON]

Thanks. I switched where the sensor was and reconfigured and it still didn’t work. I cleaned the sensor with some muriatic acid and water and put it back and now getting an additional message and pump turns off every 15 mins. What do you think?? See errors attached.

 

[ajw22]

I think you need to replace the water temperature sensor.

And you disturbed the flow switch connection so it is now not connected. See the diagram in post #2 for where the flow switch is connected.

I don't know what you did to switch where the sensor was and what you reconfigured.

 

[ajw22]

 

[ajw22]

 

[SMICON]

I think I mixed up the flow control for the temp sensor. Is the water sensor usually the same sensor as the outdoor temp sensor? My outdoor temp sensor is working.

 

[ajw22]

I think I mixed up the flow control for the temp sensor. Is the water sensor usually the same sensor as the outdoor temp sensor? My outdoor temp sensor is working.

The water temp sensor and the air temp sensor are the same.

 

[SMICON]

Air temp appears to be working but not water temp

 

[ajw22]

Air temp appears to be working but not water temp

Water temp sensor needs to be replaced...

Hayward Goldline Aqualogic Temperature Sensor Kit - GLXPC12KIT - INYOPools.com

Goldline / AquaLogic Temperature Sensor Kit w/ 15ft Leads - GLXPC12KIT

www.inyopools.com

 

[SMICON]

I figured it out. One of the wires from the temperature sensor was loose. And I messed up the flow setting the first time I opened the box and was reconnecting it, I connected it to the wrong sensor. All is working fine now. Thanks for your help.